ResourceName
Voyager 1 1-hr Averaged Triaxial Fluxgate Magnetometer (MAG) Interplanetary Magnetic Field in CDF Format
ReleaseDate
2020-07-07 21:15:53Z
Description
This data set includes the Voyager spacecraft number (1 or 2), the date-time in decimal year (90.00000 is day 1 of 1990), the magnetic field strength, F1, computed from high-resolution magnitudes, the elevation and azimuth angles in heliographic (RTN) coordinates, and the magnetic field strength, F2, computed from 1-hr averages of the components. The vector components of B can be computed from F2 and the two angles. The elevation angle is the latitude angle above or below the solar equatorial plane, and the azimuth angle is in the direction orbital motion around the Sun from the projection of the Sun-to-spacecraft axis into the solar equatorial plane. The Voyager MAG experiment and coordinates are further described in the following publication: Behannon, K.W., M.H. Acuna, L.F. Burlaga, R.P. Lepping, N.F. Ness, and F.M. Neubauer, Magnetic-Field Experiment for Voyager-1 and Voyager-2, Space Sci. Rev., 21 (3), 235-257, 1977. At the time of experiment proposal, it was expected that the required accuracy of the measurements would be 0.1 nT, determined by the combined noise of the sensors and the spacecraft field. The spacecraft magnetic field at the outboard magnetic field sensor, referred to as the primary unit, was expected to be 0.2 nT and highly variable, consistent with current estimates. Hence, the dual magnetometer design (Ness et al., 1971, 1973; Behannon et al., 1977). At distances > 40 AU, the heliospheric magnetic fields are generally much weaker than 0.4 nT; the average magnetic field strength near 40 AU and 85 AU is about 0.15 nT and 0.05 nT, respectively. The use of roll calibrations lasting about 6 hours permits determination of the effective zero levels for the two independent magnetic axes that are perpendicular to the roll axis, which is nearly parallel to the radius vector to the Sun, at intervals of about 3 months. There is no roll calibration for the third magnetic axis. Comparison of the two derived magnetic vectors from the two magnetometers permits validation of the primary magnetometer data with an accuracy of 0.02 to 0.05 nT. A discussion of the uncertainties that must be considered when using these data is given in the Appendix of Burlaga et al. (1994) and in Appendix A of Burlaga et al. (2002). References: Behannon, K.W., M.H. Acuna, L.F. Burlaga, R.P. Lepping, N.F. Ness, and F.M. Neubauer, Magnetic-Field Experiment for Voyager-1 and Voyager-2, Space Science Reviews, 21 (3), 235-257, 1977. Burlaga, L.F., Merged interaction regions and large-scale magnetic field fluctuations during 1991 - Voyager-2 observations, J. Geophys. Res., 99 (A10), 19341-19350, 1994. Burlaga, L.F., N.F. Ness, Y.-M. Wang, and N.R. Sheeley, Jr., Heliospheric magnetic field strength and polarity from 1 to 81 AU during the ascending phase of solar cycle 23, J. Geophys. Res., 107 (A11), 1410, 2002. Ness, N., K.W. Behannon, R. Lepping, and K.H. Schatten, J. Geophys. Res., 76, 3564, 1971. Ness et al., 1973.
Coordinate Systems: Interplanetary magnetic field studies make use of two important coordinate systems, the Heliographic Inertial (HGI) coordinate system and the Heliographic (HG) coordinate system.
The HGI coordinate system is used to define the spacecraft's position. The HGI system is defined with its origin at the Sun. There are three orthogonal axes, X(HGI), Y(HGI), and Z(HGI). The Z(HGI) axis points northward along the Sun's spin axis. The X(HGI)-Y(HGI) plane lays in the solar equatorial plane. The intersection of the solar equatorial plane with the ecliptic plane defines a line, the longitude of the ascending node, which is taken to be the X(HGI) axis. The X(HGI) axis drifts slowly with time, approximately one degree per 72 years.
The magnetic field orientation is defined in relation to the spacecraft. Drawing a line from the Sun's center (HGI origin) to the spacecraft defines the X axis of the HG coordinate system. The HG coordinate system is defined with its origin centered at the spacecraft. Three orthogonal axes are defined, X(HG), Y(HG), and Z(HG). The X(HG) axis points radially away from the Sun and the Y(HG) axis is parallel to the solar equatorial plane and therefore parallel to the X(HGI)-Y(HGI) plane as well. The Z(HG) axis is chosen to complete the orthonormal triad.
An excellent reference guide with diagrams explaining the HGI and HG systems may be found in L.F. Burlaga, MHD Processes in the Outer Heliosphere, Space Sci. Rev., 39, 255-316, 1984.
Acknowledgement
Please acknowledge the Principal Investigator, Norman F. Ness of the Bartol Research Institute, University of Delaware, and the NASA National Space Science Data Center (NSSDC) for usage of data from this site in publications and presentations.
Contacts
PriorIDs
spase://VSPO/NumericalData/Voyager1/MAG/CDF/PT1H
Name
B Field Magnitude by Method 2, F2
Set
Time series defined by using: EPOCH
ParameterKey
F2Mag
Description
Magnetic Field Magnitude by Method 2, F2, 1-hr Average derived from 1-hr Averages of the B1, B2, and B3 Component Data, the value is computed by using sqrt(B1^2+B2^2+B3^2)
Caveats
The vector components are computed from F2mag and the two angles for elevation (latitude) and azimuth (longitude).
Cadence
PT1H
Units
nT
UnitsConversion
1e-9>T
RenderingHints
DisplayType
TimeSeries
AxisLabel
F1 Magnitude
ValueFormat
F6.3
ValidMin
0.0
ValidMax
10.0
FillValue
999.0
Field
Qualifier
Magnitude
Qualifier
Average
FieldQuantity
Magnetic